AC3 ZoneController

AC3 ZoneController

Fingertip Power Control

Now Available for Nikon!

The AC3 ZoneController for Canon and Nikon is the gem of the ControlTL® product line.  Add it to your on-camera MiniTT1® Transmitter or FlexTT5® Transceiver and you instantly have three zones of flash control.  Whether working in E-TTL II, CLS/i-TTL or Manual mode, you now have control over all your flashes directly from the camera’s position.  Put your flashes wherever you want, without worrying about having to access them during a shoot.  With the AC3 ZoneController, you are in total control of your flash.

VIDEO:  Professional Photographer, Mark Wallace runs through the new AC3 ZoneController.

 

Three clearly labeled dials allow you to increase or decrease power to three zones of flash in 1/3-stop increments with a range of up to six stops.  Three switches allow you to change zones between Manual, Auto (PowerTracking, E-TTL II, CLS/i-TTL) or OFF.  Best of all, the design is simple with an intuitive interface.  When matched with the PowerST4 or AC9 AlienBees Adapter, you can now control ElinchromRX¹, White Lightning² and AlienBees² flashes right from the camera’s position.

Key Benefits:

•  Three independent zones of flash control
•  6 stops of flash control in 1/3rd stop increments
•  Works in PowerTracking, E-TTL II, CLS/i-TTL or Manual mode
•  Turn zones on and off remotely
•  Works with Canon or Nikon Speedlights, AlienBees, White Lightning and Elinchrom RX flash. 
•  Put your flashes where you want, without worrying about accessing them during a shoot.

 

NOTE:  The AC3 requires firmware version 5.150 (or later) be installed on paired MiniTT1's and FlexTT5's.

 

Availability: The AC3 ZoneController for Canon and Nikon is now shipping. 

 

¹Elinchrom RX flashes require a PowerST4 Receiver.  Note: Ranger RX requires EL-19374 EL Skyport Transceiver RX Adapter.
 ²White Lightning and AlienBees flashes require an AC9 AlienBees Adapter and a FlexTT5 Transceiver on the flash.